This indicator uses Tom DeMark’s TD Sequential counting from 1 to 13.
Number 9 and 13 usually identify an exhausted trend and mark a trend reversal.
The important numbers get displayed as labels (7-13), where 9 and 13 are both highlighted as "Long" or "Short".
Besides the numbers the price candles are colored based upon the sequence.
Bullish colors are...
A flexible rendition of TD Sequentials. Many parameters can be adjusted via user input.
With crypto markets trading 24/7, I wanted to adjust the behavior of the sequential counts to "dial in" a market. Default settings replicate the original TD Sequential behavior (9s and 13s), but you can select other numbers to better fit your market and timeframe.
Based on ChrisMoody CM_Williams_VIX_Fix and Glaz Matrix Series
I have difficault to enter exit trades and this is one of indicators that is helping me to get in/out in time
Applied changes are Vix multiplied by 10 to match scale and is made transparent not to confuse to much.
An aggressive scalping indicator designed for short timeframes.
Made up of:
- The 21 and 55 EMA, but these are customisable to be any length and either the: ema, sma, tema, hma or wma
- The TD sequential
- Support & resistance zones which are indicated by red and green shaded horizontal areas
The TD numbers 8 and 9 signal a possible turning point, especially if...
Having all those numbers onscreen doesn't do much for me, so I've made the important ones (i.e. the 9s and 13s) very obvious while hiding the counting. You can re-enable it in settings. Due to Tradingview limitations it can look a bit odd with them enabled, as I have made some sacrifices to prioritised visual simplicity.
I've also added alerts for the 4 different...
Sequentials Phase 1
Setup . Establish the Trend
This is the first phase of a 2 indicator set. This indicator includes Setup, Support and Resistance lines (also known as TDST ), Risk levels and some additions that are described below. Sequential Countdown is not included and will be part of the second script.
Part 1. The Price flip
The “ Price...
A version of the TD sequential indicator that also shows the 6/7 level on the chart
You can figure out the count by counting the gray crosses
For barcolor, yellow is a perfected 8-count and Blue is a perfected 9-count
Hello ladies and gentlemen
I'm back in my (almost daily) publishing challenge - to educate/show pinescript not commonly known tips
↑ Trend Direction ↓
Remember that script ?
I often use it to detect higher highs or lower lows. When an oblique/diagonal breaks, it indicates that a trend may move in the opposite direction.
Combining this along with other...
TD Countdown is the "Second Phase" of a TD Sequential.
The idea is that a TD Sequential 8 or 9 with a proper new low signal provides good odds for reversal
If that reversal doesn't happen, that's when the TD countdown happens. TD countdown waits for 13 more new lows (basically) before expiring. Once the TD countdown expires, the odds for reversal will be even...
Alert and lite version of the Setup indicator.
___ Alert list:
1. Bearish / Bullish Price flip.
--- Market closed higher than the close price four bars earlier and the prior bar’s close is lower than the close five price bars earlier, vise versa for the opposite direction.
2. Setup Count Termination
--- Market confirmed the Buy / Sell Setup termination...
Slightly modified version of the Tom Demark Sequential indicator. The setup phase doesn't require a number in the opposite direction to restart the count which means a green 1 can show up on the first candle after a green 9.
The setup phase numbers are shown on top of the candles and the countdown below the candles. An aggressive sell/buy countdown number 13 is...
A simplified version of TD Sequential which only prints the buy and sell 8’s and 9’s. The advantage of this version is it doesn’t clutter the chart with a multitude of numbers as with many TD indicators. Also a lot of the (very good) TD indicators have a lot of other featires to the TD system (S/R lines etc) that a you or I might not require.
Signals print as...
There are several variations on the classic TD Sequential indicator already published so why do another one would be a fair question to ask. Personally i wasn't fully satisfied with how many of them were implemented so i decided to code my own version from the ground up guided by the rules outlined in Jason Perl's: DeMark Indicators book. Thanks to /u/glaz and...
Once a 9 count has been reached the trend(up or down) is exhausted and indicates when to open a long or short position fairly accurately. (i find it most accurate on 1hr candles but you can backtest other candle durations to find more/other accurate candle stick times....
Indicator identifies potential price trend exhaustion.
Compares this period against the 4th prior period for the condition.
9 periods (or more) with the same condition is an indicator that the trend is ending soon.
This indicator shows a table in the top right corner with 6 cells. Each cell represent a timeframe and the current ticker's TD setup value for that timeframe. It only works on higher timeframes than what is currently used on the chart, a lower timeframe will show a gray cell and no TD setup value. The timeframes for each cell can be adjusted in settings.
This is the first script I publish. Be harsh.
About the indicator : I learned about it yesterday, it's a quite safe indicator since the condition countdown = 13 doesn't happen very often.
Numbers above chart are setup numbers
Big numbers below the chart are countdown Numbers.
Green : buy setup
Orange : sell setup
green star : sucessful buy intersection
A heat map for TD counts. If you find this useful or yank the code, please consider a donation :)